MATLAB SIMHYDRAULICS RELEASE NOTES Manual do Utilizador descarregar pdf (Página 7)

Real-Time Interface – Blocksets and Toolboxes Support 7

dSPACE Platforms: all

dSPACE Releases: 6.0 to 7.0

RTI and RTI-MP

Problem Description:

Depending on the MATLAB release in use, it is possible that some block parameters are not

accessible from the variable description file (<model>.trc file).

3.7 Simscape, SimElectronics, SimDriveline, SimHydraulics and SimMechanics

3.7.1 General Limitations

SimElectronics, SimDriveline, SimHydraulics, SimMechanics, Simscape’s Foundation

Library Blocks

Relevance:

MATLAB Releases: R2007b to R2008a

dSPACE Platforms: all

dSPACE Releases: 5.4 to 7.0

RTI and RTI-MP

Problem Description:

Simscape's Foundation Library blocks and blocks from SimElectronics and SimHydraulics are

not supported by RTI up to MATLAB R2008a.

RTI-MP Limitation

Relevance:

MATLAB Releases: R14 Service Pack 1 to R2010b

dSPACE Platforms: RTI1005 RTI1006

dSPACE Releases: 4.1 to 7.0

RTI-MP

Problem Description:

For RTI-MP, the following limitation applies:

Simscape, SimDriveline, SimElectronics, SimHydraulics and SimMechanics blocks must not be

inserted at the root level of a model. Otherwise one of the following problems will occur:

Connection lines are not copied during model separation.

Model separation is aborted with an error message.

No problems occur if these blocks are contained in subsystems.

3.7.2 TRC File Issues

Special ports and parameters not available in system description file (<model>.trc file)

Relevance:

MATLAB Releases: R14 Service Pack 1 to R2010b

dSPACE Platforms: all

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

MATLAB SIMHYDRAULICS RELEASE NOTES Manual do Utilizador Página 7